Living organisms (yeast and bacteria) were not identified as the agents that produced or spoiled common food items until the 19th century. Baking, especially of bread, was among the first industries to be transformed by the emerging scientific understanding of fermentation. The introduction of commercialized yeast in the early 20th century steadily reduced the time needed to bake bread both at home and on the production line, making way for modern packaged breads (1). However, traditional fermentation techniques, including sourdough breads, have resurged in popularity. Typical sourdough cultures are created from yeast and bacteria populations naturally present in the air and on many surfaces, providing sourdough loaves with their characteristic rise and “tangy” flavor by converting fermentable sugars into CO2 and flavor compounds like lactic acid. In this application note, a “homemade” sourdough starter culture was analyzed to determine how key fermentation products changed over the course of 24 h with the new Rapid SUGAR SH1011 8C.
The Shodex™ Rapid SUGAR SH1011 8C contains a styrene divinylbenzene base material ligand exchange column and is designed for rapid fermentation monitoring, allowing for the analysis of saccharides, organic acids, and ethanol in less than 5 min. The method uses simple aqueous conditions and RID detection, ideal for large sample workflows and QC environments.
Experimental
Seven common fermentation compounds (maltotriose, maltose, glucose, lactic acid , acetic acid, glycerol, and ethanol) were used as standards.
The sourdough starter culture was adapted from King Arthur (2) with the procedure repeated daily for 14.
Sample preparation
Approximately 10 g of sample was homogenized with 90 mL distilled water (maximal speed, 30 s, blender). Five milliliters of 1 mol/L HClO4 solution was added to a 10 mL aliquot of the homogenate. The mixture was centrifuged for 15 min at 4000 g at 15 1C, the supernatant was neutralized (pH 7.0) with 2 mol/L KOH and the volume was adjusted to 25 mL with distilled water. After 30 min precipitation on ice, the solution was filtered on 0.45 mm cellulose filter, adapted from reference 3.
Samples were taken starting on Day 15 at three time points
Sample 1: Immediately after mixing in flour and water, labelled time 0
Sample 2: 12 h after time 0
Sample 3: Day 16, approximately 24 after time 0
Shodex SUGAR SH1011 8C (8.0 mm I.D. × 100 mm, 6 μm) was used with a Shodex RI-501. The eluent conditions were: 1 mM H2SO4 aq. The column was kept at 75 ºC and the flow rate was 1.0 mL/min. The chromatography was performed on a Shimadzu Prominence I series LC 2030.
Results and Discussion
This simple method using 1 mM sulfuric acid as the eluent demonstrated a successful simulated analysis of fermentation by-products in less than 5 min, including the column equilibration time.
For the analysis of the sourdough starter culture a guard column was used: (Shodex™ SUGAR SH-G (6.0 × 50 mm id, 10 μm) (Figure 2).
A method for rapid fermentation monitoring was developed using the Shodex SUGAR SH1011 8C column. Fermentation sample measurement completes in 6 min. The column showed good robustness when used with complex sample matrixes like sourdough cultures. The results show that the SH1011 8C can be used to monitor fermentation products like organic acids and ethanol.
References
Shodex™/Showa Denko America, Inc.
420 Lexington Avenue Suite 2335A, New York, NY, 10170
tel. (212) 370-0033, X116, fax: (212) 370-4566
Website: www.shodexhplc.com